Wiring the Printrbot

Wiring is pretty simple, pretty much just plug all plugs in to the board and get the motor ones around the correct way.

Wired Up Board

Since I had tucked my X-Axis and Z-Axis motor wires into the body before putting the screws in, I had no space to route the cables through the hole and out the back.

Temporary Cable Management!

Decided to fix it all up later so I can get to the printing...

Ready To Go!

Next Steps:

• Software Install
• Calibration
• Test Print
• Print a Fan Shroud
• Print Printer Upgrades