The control board for the Printrbot just screws into the plywood frame, and ends up sitting on a bunch of zip-ties. A fairly terrible design, and there are cables going everywhere. To fix this a Printrboard mount and cable management solution is required.
Part 1 - Printrboard Mount
Design in Autodesk 123D Design, and model the height of all the plugs so we can print something for the cable management too.Start with 2D layout. |
Extrude. |
Added plug height. |
Mount with riser for cable ties. |
Dividing up for printing. |
Printed. |
No comments:
Post a Comment